Main Filter Controls

• Filter tabs. Click to select Filter 1 or Filter 2
• Filter enabled Switch: turns the filter on and off

• Screen: Shows the frequency curve for the selected filters. Dragging the screen will adjust the base Cutoff and Resonance levels
• Filter Mode Selector: Choose between the different Filter modes

Filter Mode

The following controls are available when the filter is set to MG Ladder, MS 200, or Clean mode

• Filter shape selector: Choose Low pass, Band pass or High pass
• Filter slope selector: allows 12 or 24 Db per octave
• Cutoff knob: controls the frequency of the selected filter. A good modulation target - try dragging Env 2 to the cutoff
• Keyfollow Button: when enabled, adjusts the cutoff based on the note being played. The cutoff knob becomes an offset knob
• Link Button: links the cutoff of filter 1 and filter 2
• Resonance:
• Drive: Adds a drive amount to the filter circuit. The drive is different for each mode. Clean mode does not have a drive circuit
• Mix: blends the output between the filtered and dry signals.

EQ Mode

The EQ is split into 3 bands.

The controls correspond to the selected band.

• Low and high bands can be switched between an low / high pass filter and a shelf.
• Pass filters have a slope switch, while shelves have a gain control.
• The mid band be switched between a bell and a notch.
• You can drag the handles in the EQ graph to quickly adjust the 3 bands.

Formant Filter

• Drag the handle in the EQ graph to change between the four vowel sounds.
• Vowel X and Vowel Y: adjust the X and Y positions of this handle
• Voice: adjusts the formant between female and male voices
• Shift: moves all adjustments up and down in frequency
• Mix: blends between the dry and filtered signal

Comb Filter

• ABC switch:
• Keyfollow Switch: adjusts the cutoff to match the note you play. When in this mode, the cutoff knob becomes an offset knob

Resonator

• Keyfollow Switch: adjusts the cutoff to match the note you play. When in this mode, the cutoff knob becomes an offset knob
• Link: Links the Filter 1 cutoff to the filter 2 cutoff
• Low cut enabled:
• Band Selector: Choose the number of bands
• High cut enabled:
• Alight Centre / Left switch: determines whether the centre resonator band or left band frequency is set to the cutoff
• Cutoff: The frequency of the left or centre band
• Res: adjusts the resonance of each band. At high values the filter will self oscillate
• Skew: adjusts the distribution of the bands towards the left or right
• Range: sets the distance between the lowest and highest band
• Mix: blends between the dry and filtered signal