Effects Routing
- Click on an effect heading to expand it and access the effect's controls
- Drag the effect up or down
- Effects Routing button changes the effect's routing mode between series, parallel, and frequency split
- Preset Load button loads an effects preset, which applies predefined parameters to all effects, including routing
- Preset Save button saves the current effects chain as a preset
Series Mode
In series mode, the output of each effect is fed into the input of the next.
Parallel Mode
In parallel mode there are two effects busses which are applied simultaneously. You can drag effects between them.
- Input mix knob controls how much signal is fed into each bus
- Output mix knob controls how much of each bus is fed to the output
Dual Filter Routing
An additional section appears in parallel mode that allows you to choose which busses the filter is routed to.
Frequency Split Mode
In frequency split mode you can apply effects to the high or low end of the signal by putting them in the appropriate bus. For instance, you could add a reverb for just the high end, and compress just the low end of the signal.
- Crossover knob splits the signal into high and low frequency content
- Output Mix knob controls how much of each bus reaches the output